Victron Energy VECIP22-12/30-3

Victron Energy VECIP22-12/30-3

Blue Smart IP22 SLA/LiFePO4 Charger 12V 30A Triple Output Fan Assisted BPC123044012 (AU/NZ Plug)

Important Information:

All Batteries connected to this charger MUST be capable of a maximum charge rate of either 30 Amps or 15 Amps dependant on whether high or low current mode is selected.

There is no individual charge cycle for each separate battery, therefore all batteries will follow the same charge cycle.

As this charger contains an integrated FET battery isolator, it is therefore possible to charge three batteries with a single charger whilst keeping the batteries isolated. Charging current is divided among the batteries dependant on battery state of charge in combination with battery parameters and other circuit parameters.

The charger, when connected to multiple batteries will raise the voltage of the lowest battery at the selected full current until it matches the second lowest battery voltage. At this point the available current is spread between these two batteries. When the voltage of the two batteries then matches the third battery the current is divided between the three batteries. All batteries will then reach absorption phase together and cycle together.

Bluetooth Smart enabled:
The Blue Smart IP22 Charger is the wireless solution to monitor voltage and current, to change settings and to update the charger with the Victron Connect app when new features become available.

Victron Connect:
Victron connect lets you program, as well as get live status and historical information from Victron products with built-in blue tooth support or by using a VE.Direct Bluetooth Smart dongle.

History File:
View historical data for the last 40 charge cycles. Information supplied includes Start and End voltages, time spent in each charge cycle, amp-hours charged, Completion status of each charge and charge profile used.

High efficiency:
With up to 94% efficiency, these chargers generate up to four times less heat when compared to the industry standard.
And once the battery is fully charged, power consumption reduces to 0,5 Watt, some five to ten times better than the industry standard.

Adaptive 6 - stage charge algorithm: test - bulk – absorption - recondition – float – storage:
The Blue Smart Charger features a microprocessor controlled ‘adaptive’ battery management. The adaptive feature will automatically optimize the charging process relative to the way the battery is being used.
These chargers come standard with pre-set algorithms which are optimally set for all common Lead Acid and Lithium Batteries. For Battery Manufacturer specific settings, Expert mode allows changing practically all parameters and time limits used by the charge algorithm.

Storage Mode: less maintenance and aging when the battery is not in use
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 2,2V/cell (13,2V for a 12V battery) to minimize gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulfation, a major cause of early battery failure.

Also charges Li-ion (LiFePO4) batteries
LiFePO4 batteries are charged with a simple bulk – absorption – float algorithm.

NIGHT and LOW setting
When in NIGHT or LOW mode, the output current is reduced to max. 25% of the nominal output and the charger will be totally noiseless. The NIGHT mode automatically ends after 8 hours. The LOW mode can be ended manually.

Protected against overheating
Output current will reduce as temperature increases up to 50°C, but the Blue Smart Charger will not fail.

Eleven LEDs for status indication
Charge algorithm: TEST / BULK / ABSORPTION / RECONDITION / FLOAT / STORAGE / READY.
MODE button to set: NORMAL (14,4V) / HIGH (14,7V) / RECONDITION / LI-ION




SHARE:
Selling Unit EACH
Model No VECIP22-12/30-3
Brand Victron Energy brand logo
Original Brand Victron Energy BPC123044012
Description Blue Smart IP22 SLA/LiFePO4 Charger 12V 30A Triple Output Fan Assisted BPC123044012 (AU/NZ Plug)
Voltage 12V
Size 30A
Width 65mm
Height 235mm
Length / Breadth / Depth 108mm
Weight 1300g
Categories Battery Chargers / Analysers / Testers
Lead Acid Battery Chargers
12V Battery Chargers
Lithium Iron Phosphate Chargers
Multi Chemistry Chargers
SLA/GEL Type Chargers
LiFePO4 Type Chargers
Power Supplies
AC-DC Power Supplies
Blue Smart Range
Blue Smart IP22 Range
Data Sheet Datasheet PDF Thumbnail icon Datasheet PDF Thumbnail icon

Login to MI Link for pricing
Login for Pricing
MI Link is a dealer-only portal. If you are not a current MI account holder register for an account

Victron Connect app compatible

VictronConnect Compatible

VictronConnect lets you get live status information and configure any Victron Energy products via either Bluetooth or direct cable connection. Connect to Bluetooth equipped products, or non-Bluetooth equipped products using VE.Direct Bluetooth Smart Dongle. Connect directly to equipment using the VE.Direct to USB Interface (USB Type-A) or VE.Direct to Type C Interface (USB Type-C) cables.

Find out more about VictronConnect here, or download the App via these links. Click here to download the VictronConnect Manual.

Apple App Store

Apple Mac store

Google Play Store

Windows Download

Back to the top of page MI Link Contact Us